NORLYS

Aplică de exterior NORLYS Lillehammer 2280WH albă, LED 9 W 4000 K, sus-jos, IP65, IK08, DALI-2

Name: Aplică de exterior NORLYS Lillehammer 2280WH albă, LED 9 W 4000 K, sus-jos, IP65, IK08, DALI-2
Brand: NORLYS

Lillehammer 2280WH is an outdoor wall light from the Norwegian brand NORLYS — a compact, cuboid body in cast aluminium, finished white, throwing light up and down. LED 9 W, 4000 K, IP65. 127 lumens from the fitting — this is accent light, not area lightThis is the thing to understand before buying, and it needs two different numbers explained. NORLYS publishes both:Luminous flux of the light source: 1008 lm from a 5.6 W module — that is 180 lm/W, a genuinely high figure, and it is what the energy class C is based on;Luminous flux of the luminaire: 127 lm at 9 W total system power — that is 14.1 lm/W.The gap is not an error. Lillehammer releases roughly 12% of the light the diodes make, because the optic deliberately squeezes the output into two narrow beams. The practical conclusion is unambiguous though: this is a decorative and wayfinding fitting. It marks a wall, draws two triangles of light on it and shows a route — but it will not light a driveway or a terrace. If you need usable light, plan on several units or on a different fitting. Up and down: 4° up, 60° downThe fitting emits in two directions, but the two beams are completely different. NORLYS gives 4° upward and 60° downward (or the reverse, depending on how it is mounted).Four degrees is a beam almost parallel to the wall — it draws a narrow, hard wedge of light running vertically upward and picks out the texture of render, brick or timber. Sixty degrees downward gives a far wider pool that reaches pavement level. The effect is asymmetric by design: a fine accent above, a usable pool below at the door.The ULOR figure of 20% says one fifth of the emitted light goes above the horizontal — relevant wherever local light-pollution rules apply. DALI-2 controlLillehammer 2280WH carries a DALI-2 driver, which is not a given on an outdoor fitting this size. It means smooth dimming and addressing on a bus rather than plain on/off.That earns its keep on a larger installation: a façade with eight or twelve of these can run at 100% until midnight and 30% until morning, without changing the fittings and without separate circuits. Control of course requires a DALI bus and a controller — this fitting will not work on an ordinary leading-edge dimmer. Durability and installationIP65 is full dust protection plus resistance to water jets — the fitting takes rain driven straight at the façade. IK08 means resistance to a 5 J impact, the level appropriate to publicly accessible positions: by a gate, beside a pavement, in an external stairwell.Installation is specified precisely, and it is worth checking before drilling:Two Ø 5 mm holes at 45 x 130 mm centres;Terminals up to 5 x 1.5 mm², with loop-through wiring — successive fittings connect in series without a separate junction box;The gland accepts a round cable of 7–10.5 mm diameter.Protection class I requires an earth conductor. The operating range is -20 to +45 °C, so the fitting is built for a northern winter. Specification Product code: 2280WH | EAN: 7042890228013 | Series: Lillehammer Dimensions: 18.5 x 11 x 8 cm | Net weight: 1.60 kg | gross: 1.80 kg Material: painted cast aluminium, EPDM gland | Colour: white Luminaire power: 9 W | Light source power: 5.6 W Luminaire flux: 127 lm | Source flux: 1008 lm Source efficiency: 180 lm/W | Luminaire efficiency: 14.1 lm/W Energy class: C | Colour temp: 4000 K | CRI: 80 | SDCM: 3 Distribution: 4° up / 60° down | ULOR: 20% Control: DALI-2 | Supply: ~220–240 V Power factor: ≥ 0.88 | THD: 13% | Inrush current: 6.7 A / 2.4 µs IP: 65 | IK: 08 | Protection class: I Operating temperature: -20 to +45 °C | Service life: 52,330 h Inrush current — what to plan for on a larger runNORLYS states an inrush current of 6.7 A over 2.4 µs per fitting. On a single wall light that is irrelevant, but with a dozen on one circuit the pulses add up and can trip an ordinary miniature circuit breaker at the moment of switch-on.For a façade carrying a dozen or more fittings, plan a type C or D breaker, or split the installation across several circuits. This is exactly the parameter whose absence from a datasheet causes lighting to “mysteriously” trip out at dusk.Afișează mai mult

de la 934,34 RON

1 ofertă

Vezi ofertele