Lumines

LED PRO D MINI connector for 8 mm single color COB LED strips - DC 2.1/5.5 socket

Name: LED PRO D MINI connector for 8 mm single color COB LED strips - DC 2.1/5.5 socket
Brand: Lumines

The LED PRO D MINI connector 24-1100-93 connects an 8 mm single-colour COB LED strip to a DC 2.1/5.5 socket. A cable runs between the transparent strip clamp and the white socket. This version brings power to the strip rather than joining two lengths of strip together.Check the strip and power connectionThe strip end uses two contacts. Before ordering, compare your strip's PCB width and contact-pad arrangement with the intended application: single-colour COB strip, 8 mm wide. The family also contains versions for SMD strips and 10 mm COB strips, so the PRO MINI name alone does not identify the right connection. Check the article number as well as the strip type.The connector supports 5, 12 or 24 V DC with a maximum current of 2 A. The power supply voltage must match the strip, and the current passing through this connection must remain within that limit. The 2 A figure is a current rating, not a power rating in watts. On the supply side, check that the plug matches the DC 2.1/5.5 socket.A solder-free clamp with a short leadCopper pins pierce the PCB when the clamp is closed, making the connection without soldering. The transparent polycarbonate housing leaves the connection area visible. The clamp measures 18 × 10 × 5 mm, while the lead is 15 cm long with two 0.3 mm² conductors. Allow space for both the clamp and the cable route to the socket.The manufacturer describes PRO MINI installed in a D profile; compare the available space with the clamp dimensions. Both IP20 and IP65 strips are supported, but retaining IP65 requires sealing the connection itself. Closing the latch is not a substitute for that sealing.Meer tonen

vanaf € 1,00

1 aanbieding

Bekijk aanbiedingen